.jpg)
step 1: preparing your materials
Prepare your work environment. Organizing your tools and materials will help
you work faster and more efficient.
Cut two small cords of leather, into 12cm long pieces.
Step 2 : connecting the bracelet
Open the first 5mm jump ring with the help of the plier tool and close it to connect the center piece with the 6mm jump ring.
Take one of the leather cords and fold it in half, insert the cord through the 6mm jump ring.
Now, slide the ends of the cord through the loop of the leather, and pull it until it holds the jump ring tightly.
Use a small 5mm jump ring to hold the leather tightly in it's place.
Step 3: closing the bracelet
To close the bracelet all four end of the leather needs to be held by the metal ends.
Put the metal ends on the leather edge and use the pleir tool to press it until it closes tightly on the leather.
Us 5mm jump rings to connect the clasp and an extra 6mm jump ring to close the bracelet.
Step 5: setting the stones
Place the stone in the center of the stone setting and with the help of the setting tool bend the prongs towards the stone in order to embed it.
Bend the prongs gently to make sure you don't damage the stone or crack the plating in this process.
great!
The bracelet is ready!
Enjoy your new beautiful Swarovski bracelet.
Gita team.
