Step 1: preparing all of the materials
Prepare your work environment. Organizing your tools and materials will help
you work faster and more efficient.
Step 2 : First bracelet
Use 6mm jump ring, and 5mm jump rings to hang the small metal pendent from the center piece.
Also hang small 5mm jump rings on each side of the metal flower.
Use small amount of E6000 glue and set the stones in there place.
Open 6mm jump rings and hang the metal flower on the leather cord.
Use the metal ends to close the bracelet.
With the help of the plier tool press the metal end until it's closed and holds the leather tightly.
Connect the clasp and extension chain at the end of the bracelet.
Great! This bracelet is ready!
Step 3 : Second bracelet
Fold the leather cord in half, and slip it inside the first link of the chain.
Make a tie by slipping the ends of the cord in to the loop.
Pull the leather until it holds the metal loop tightly. Make the same tie on both sides.
Use the metal ends to close the bracelet, and open the loop of the clasp to connect it to the loop on the metal end.
Second bracelet id done!
Step 4 : third bracelet
Use a metal end, and push the tree leather cords inside.
With the help of the plier tool press the metal end until it's closed and holds the leather tightly.
Make a braid from the leather cords.
Close all three ends together with the metal end, and connect the clasp and extension chain with metal label and Swarovski stone.
Use 5mm jump rings to hang the butterfly stone settings on the leather.
Now, set the stones.
Place the stone in the center of the stone setting and with the help of the setting tool bend the prongs towards the stone in order to embed it.
wonderful!
All the three bracelets are ready!
Enjoy your new beautiful Swarovski bracelets.
Gita team.